Clone A Willy

Make the ultimate realistic vibrator, moulded on a real penis - YOURS! The kit contains everything that you need to make a copy of your penis as a fully functioning vibrating dildo. The Clone a Willy kit includes - moulding powder, liquid rubber, Vibrator, moulding tube, penis ring, thermometer and easy to follow instructions. All that is required is a hard cock and water.

The kit is easy to use if you read the instructions carefully before you start and follow them step by step. Before you begin you must get together everything you need. As well as the 'ingredients' supplied above you will also need a pair of scissors to cut the tube to the right size, some duct tape to make the end of the tube smooth, a large mixing bowl, an accurate timer, a wooden spoon for mixing, a 4inch square piece of cardboard and a measuring jug.

It is important to get the water to the required temperature and use at once. When you have added the moulding powder to the water you will only have two minutes to mix it into a soft paste, add it to the mould tube and put your erect penis into it. After two minutes the mould material will be too hard. It is easier if you have a 'friend' to help you mix the powder and maintain your erection. A good tip is to use the penis ring to help maintain the erection. You don't need to maintain your erection until the mixture fully hardens so long as it is erect to start with.

After a few minutes the penis is carefully removed from the mould.

Let the mould set for two hours before use but not too long or it will dry out. Mix the two part rubber mixture thoroughly and pore it carefully into your mould. Place the vibrator into the rubber filled mould and leave to set for 24 hours. Carefully remove your new replica vibrator from the mould. Now you will have a realistic life size model of the real thing!

To make the model vibrate you will need one AA battery. We include a quality alkaline battery free with your order.